SECTION WIRE MESH PARTITIONS PART 2 PRODUCTS

PART 2 PRODUCTS 2.01 MATERIALS MAKE SURE WIRE GAGE & MESH ARE SHOWN ON DRAWINGS. A. Wire: Cold drawn steel wire. MAKE SURE FRAME SIZES ARE SHOWN ON DRAWINGS. 1-1/2 INCH CHANNEL IS REQUIRED FOR THE FRAMES OF HINGED DOORS WITH DEADLOCKS. B. Frames: Cold rolled steel channels. 1. Frames for Hinged Doors with Deadlocks: Minimum 1-1/2 inch channels. CHECK PARAGRAPH BELOW AGAINST DRAWINGS AND EDIT AS REQUIRED. ADD PIPE IF NEEDED FOR SPECIAL ANGLE CORNERS. C. Vertical Posts: Cold rolled steel bars, angles, or channels, or cold drawn steel tubing. D. Floor Sockets: Ductile iron (weldable). E. Top Capping Bar: Continuous cold rolled steel channel. F. Door Hardware: Hardware mounting screws shall be inaccessible from the secure side of the door when the door is locked. 1. Hinged Doors: Manufacturer’s standard fixed pin steel hinges. NOTE: LOCKS TO BE “less cylinder” IF MASTERKEYING IS REQUIRED. 2. Sliding Doors: Manufacturer’s standard track system, hangers, cylinder hook-type lock, and bottom guide channel. ADD BRACING (FLOOR OR OVERHEAD) TO PARAGRAPH BELOW OR IN A SEPARATE PARAGRAPH WHEN REQUIRED. G. Accessories: Manufacturer’s standard fasteners and accessories, unless otherwise shown. H. Shop Paint: Steel primer selected from the following: 1. TNEMEC 10-99 (Red), 10-99G (Green) or 10-1009 (Gray). 2. Rust-Oleum 769. 3. Valspar 13-R-53. 4. Sherwin-Williams “Kromik”. USE PARAGRAPH ABOVE OR BELOW. COORDINATE WITH SECTION 099101. I. Shop Paint: Partition manufacturer’s standard enamel shop paint. 1. Color: As selected from manufacturer’s standard colors. 2.02 FABRICATION A. Comply with Woven Wire Products Association’s Standards and the AWS Code unless otherwise specified or shown. B. Panels: Tenon and weld frame members at intersections. Wire shall be crimped and woven with ends of wire extended not less than l inch through the frame and clinched back on the frame at least 90 degrees. Center mesh in the frame. Tack weld every third wire to back of the frame. DELETE PARAGRAPH BELOW IF NOT REQUIRED. C. Cut Outs: Fabricate partitions with framed cut outs for penetrations through the wire mesh partitions. WIRE MESH PARTITIONS D. Shop Painting: Thoroughly clean wire mesh partitions and apply one coat of shop paint.